Knowledgebase
Knowledgebase: Support > VCM Editor
The data you just read isn't from your vehicle- pop up

A growing number of vehicles/controllers are unable to be read through the OBD2 port, however these modules can be flashed without issue. 

To combat this when VCM Editor sees one of these modules, it will generate a stock calibration based off the vehicle information it detects. 
This is nothing to be alarmed about but understand if your vehicle had been previously tuned you WILL lose the tune that was in it the module as VCM Editor can only generate the STOCK calibration.

If you are willing to accept that it is the stock calibration, simply click OK & tune.

(0 vote(s))
Helpful
Not helpful

Comments (0)